DOTECO at Plastfocus New Delhi — 36 sqm Exhibition Stall Design for Extrusion Components

Project Details

Extrusion halls are dominated by full lines two storeys high, and DOTECO's business is what goes inside them — gravimetric dosing units, die heads, control gear. Placed on a table, those parts disappear. On a 36 sqm plot at Yashobhoomi with 2 open sides, the exhibition stall design at Plastfocus New Delhi had to lift components into view and give visiting process engineers somewhere to sit and question them.

Materials Used

Extrusion halls are dominated by full lines two storeys high, and DOTECO's business is what goes inside them — gravimetric dosing units, die heads, control gear. Placed on a table, those parts disappear. On a 36 sqm plot at Yashobhoomi with 2 open sides, the exhibition stall design at Plastfocus New Delhi had to lift components into view and give visiting process engineers somewhere to sit and question them.

White raised deck, so the stand reads as a clean platform against the red aisle carpet. Components go up: a dosing unit on a steel pillar at head height, and a die head on an angled plinth, section facing the aisle. The rear bay is yellow with a backlit product panel, printed boards run the flank, and wood-finish battens clad the corner column. The lounge sits behind the hardware, keeping the exhibition stall design at Plastfocus New Delhi walkable on both open sides.

Raising the parts to eye level changed what the stand was. Instead of glancing at a table, visitors circled the pillars, looked into the die head and asked about it — the photographs show people gathered around those two pieces. Putting seating behind kept the front edge clear, which matters in a dense hall. The white deck also gave the 36 sqm booth a visible boundary.